9
CO-100 Offl ine Lock User Guide
LOCK STATUS REPORTS
Follow the steps below to obtain lock status reports:
Lock status reporting is available with fi rmware version 2.5.0 or higher.
The left and right Schlage button LEDs will blink red once with each button press, followed by the
status indicator as described below.
Function / Report
Press
Indicator/Report Result
Initiate report
mode
Press and hold
while pressing
Wait until only the right Schlage button LED is on
to indicate the lock is in report mode and awaiting
an entry. If no entry is made, then timeout will
occur in 20 seconds.
Battery status
Left LED:
Solid green = excellent
Blinking green = good
Blinking red = low
No indicator = critical battery
Once a status is reported, both left and right LEDs will light green, followed by solid green
on the right LED only. The right green LED indicates the lock is awaiting another entry.
Obtain an additional status report as described below, or press
to exit report mode.
Function / Report
Press
Indicator/Report Result
Firmware status
Left LED blinks green for the version number
Decimal point is indicated by one red blink
“Zero” is indicated by two red blinks
Hardware status
PCB serial
number
Left LED blinks green for each number
Each number is separated by two red blinks
Press
after two red blinks to display the next
number
If no entry is made within 20 seconds of the solid green right LED, then timeout will occur.
To exit report mode at any time, press
.