13
d.
Wall Mount:
Use the bracket as a template to mark the two mounting holes. Mount to
the wall using screws, and wall anchors if necessary (not provided).
Fully tighten the
loose screws and nuts (steps b and c). Tighten all mounting bracket screws at a
torque of 30 inch lbs.
Pole Mount:
Attach the
pole brackets to the pole
as shown. Secure the pole
brackets with two 5-inch
screws, a washer and a
helical spring lock washer
on each side. Adjust to
the desired angle.
Fully
tighten the loose screws
(steps b and c). Tighten
all mounting bracket
screws at a torque of 2.5
ft-lbf (3.4 N-m).
Minimum diameter 1” (25 mm)
Maximum diameter 4
C|v
” (120 mm)
Pole mount shown
Testing
Test to verify that the antenna has been correctly installed:
L
If you encounter problems while performing the following tests, refer to the
Troubleshooting section in this guide and/or within the applicable WAPM user
guide.
1. Place the PIM400 into link mode. Refer to the PIM400-485 User Guide or the PIM400-
TD2 User Guide, in “Link Mode” section.
2. Place the WAPM into link mode. Refer to the AD400/AD401 or WRI400 User Guide, in
“Link to a PIM400” section.
3. Verify that the WAPM links successfully with the PIM400. Refer to the label located
inside the PIM400 enclosure for LED blink patterns that indicate successful linking.
