2
STEP 1
Place the TouchBar on the door and measure the distance
between each end and the stop (or frame on a blade stop
door). It should be at least 3/8” of an inch. If so, proceed
to step 2. If not, the TouchBar will need to be cut to size.
1.
REMOVE END CAPS AND BRACKETS
.
2.
REMOVE PIVOT HINGE COMPONENTS AND
SWITCH COMPONENTS
.
KEEP THE PIVOT
HINGE AND SWITCH ASSEMBLIES TOGETHER
WHEN DISASSEMBLING DEVICE
.
3.
SLIDE OUT PUSH PAD AND EXIT SIGN
(
IF FURNISHED
)
AS SHOWN
.
SLIDE OUT
COVER PLATE
.
SWITCH ASSEMBLY
CROSS SECTION OF SWITCH AREA
:
SWITCH LEVER
SWITCH
PUSHBAR END CAP
SPRING
SWITCH ADJUSTMENT SCREW
PUSHBAR END CAP BRACKET
PUSHBAR
END CAP
:
SEE INSET
BELOW
3/8”(min)
3/8”(min)
SLIDE PUSHBAR END CAP UNDER
SWITCH LEVER AND CAPTURE
SPRING
.
SEE BACK COVER FOR COMPLETE EXPLODED VIEW.
CUTTING TOUCHBAR TO SIZE:
A.
Measure the DOOR WIDTH, hereafter referred
to as dimension “X”
HOLLOW METAL OR WOOD DOOR
:
DIMENSION “X”
B.
Disassemble the TouchBar as shown below:
CHANGING HAND:
1. REMOVE SWITCH SIDE
END CAP AND PUSHBAR
END CAP.
2. REMOVE “PUSH TO EXIT”
SIGN AND INSERT AND
REVERSE LETTER DIREC-
TION.
3. REFER TO THIS PAGE TO
RE-INSTALL END CAPS.
SWITCH SIDE END CAP
COVER PLATE
INSERT
PUSH PAD
