14
QUICKCAT
CONTROL LEVERS (L & OP)
- Each of the
two control levers controls the drive wheel located
on its side. They control the forward and reverse
movement of the machine, provide steering and also
provide dynamic braking.
The left control handle is the operator presence. The
operator presence must be held down for PTO opera-
tion and when machine is NOT in park. If the PTO
switch is on or machine is NOT in park, the engine
will kill.
HEIGHT OF CUT (HOC) HANDLE (X)
- Used
to secure the cutterdeck in transport position. To
return to preset height of cut, lower HOC handle until
latch lever contacts height of cut pin
A
.
FUEL GUAGE (U) -
Shows the level of fuel
remaining in tank.
HEIGHT OF CUT(HOC) PIN (A)
- Sets height
of cut and allows easy return from transport to
desired height of cut. Raise the deck to transport
using the HOC handle. Position pin
A
in the hole
corresponding to the desired height of cut. Lower the
HOC handle until it rests on pin
A
.
OIL PRESSURE MALFUNCTION LIGHTS
(S)
- Indicates low engine oil pressure when lit.
NOTE:
When starting the engine, the indicator light
will come on breifly as an engine system check. If
the light stays on after initial start-up, shut off engine,
and check the oil level. If the indicator light continues
to stay on, contact an authorized dealer.
ENGINE CONTROL UNIT MALFUNCTION
LIGHT - ECU (E)
-Indicates an issure with the
control unit when lit.
NOTE:
When starting the
engine, the indicator light will come on briefly as an
engine system check. If the light stays on after initial
start-up, shut off engine, verify the battery cables
are connected properly and the battery is properly
charged. If the indicator light continues to stay on,
contact an authorized dealer.
EFI UNITS ONLY
CONTROLS
