13
REN-O-THIN
BLADE HEIGHT ADJUSTMENT
To adjust blade height:
1. Lower the blades to the operating position by
moving the lift lever forward.
2. Turn the adjusting knob to raise or lower the front
wheels . Make the initial adjustment on a hard
level surface.
3. Set
flail blades or spring tines
to 1/8” (3mm)
above the surface initially. Test this setting on a
small area, then, adjust to conditions as required.
Each mark on the adjustment label equals 1/8”
(3mm).
OR
Set
fixed
blades 1/8” above the surface for
dethatching or verticutting, 1/8” (3mm) below the
surface for seeding. Test the setting on a small
area and adjust to conditions as required.
If the desired position cannot be obtained
with the front wheels , the rear wheels may be
remounted. The top set of holes lowers the
blades, the bottom set raises the blades.
ADJUSTMENTS
