9
Classic
Pro
GENERAL INSTRUCTIONS
OPERATING ON SLOPES
USE EXTRA CARE WHEN WORKING ON SLOPES
•
With walk behind machines, mow across slopes,
not
up and down. With ride-on machines, mow up
and down slopes,
not
across, except for zero turn
machines. Zero turn machines should mow across
slopes.
•
Be alert to dips and rises which change the general
slope. Watch for holes, rocks and roots in the terrain
and other hidden hazards. Keep away from drop
offs. Avoid ground conditions which will cause the
machine to slide.
•
If the operator is uncomfortable or unsure of the
machines stability, operation on these slopes should
cease immediately.
•
The ultimate responsibility for safe operation on
slopes, rests with the operator.
•
Use lower speeds and exercise extreme caution
on slopes and especially in sharp turns to prevent
tipping and loss of control. Use extra caution when
changing direction on slopes.
LEAVING THE DRIVING POSITION
Park the machine on level ground. Before leaving the
driving position, stop the engine, make sure all moving
parts are stationary and that the traction control levers
are in the neutral position. Apply parking brake, if so
equipped.
MAINTENANCE AND ADJUSTMENTS
•
Disconnect spark plug wire(s) before doing any
maintenance.
•
Particular care must be taken when adjusting the
carburetor while the engine is running. Keep hands
and feet clear. Shut off PTO.
•
When working underneath lifted parts or machines,
make sure adequate support is provided.
•
Do not dismantle the machine without releasing or
restraining forces which can cause parts to move
suddenly.
•
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
•
Check the grass catcher frequently for wear and
deterioration.
•
Replace worn or damaged parts for safety.
STORAGE
•
Never store the equipment with gasoline in the tank
inside a building where fumes may reach an open
flame or spark.
•
Allow the engine to cool before storing in any
enclosure.
•
To reduce the fire hazard, keep the engine, muffler,
battery compartment (if equipped) and gasoline
storage area free of grass, leaves or excessive
grease.
•
If the fuel tank has to be drained, this should be
done outdoors.
•
Use only replacement parts supplied by the original
manufacturer.
Summary of Contents for BOB-CAT 33007J
