Magnetic Drilling Machine
Operating Manual
8 If the slug gets stuck in the cutter, move the machine to a flat surface. Switch
on the magnet and gently bring the cutter down in contact with the surface.
This usually allows a slug to straighten and to eject.
WARNING: THE SLUG WILL BE EJECTED AND IS VERY HOT
5.3 Drilling with twist drills
There are several accessories available to be able to use twist drills with your
magnetic drill.
7 After the cut is finished the slug will automatically be ejected from the cutter,
switch the machine off by pushing the red button(0).
- Adapter 19 mm Weldon - ½”x20 UNF
- Adapter 19 mm Weldon – B18 taper connection
- Adapter 19 mm Weldon – B16 taper connection
6 Start bringing the cutter to the workpiece but handle with care and do not
apply too much pressure. The cutter has to find its way in to the material by
itself. After 2 mm, the groove of the cut will help the cutter maintain its place
and you can increase the power. Still it is not necessary to use a lot of
pressure. Too much pressure will cause damage and breakage.
1 Place the machine at the desired position
Also twist drills with a direct Weldon connection are available
2 Switch on the magnet
These adapters will allow you to attach a drill chuck on to the hole cutter arbor.
(ranging from Ø 6 – Ø 12 mm)
SWC 50 WT
11
Drill Chuck
Weldon Drill Chuck Adaptor
Taper shank twist drill