4.2. Install Power Supply
4.2.1. Tools and Materials
To install the power supply, you will need cable holders and clamps (P/N B4700140) to
secure the cable along the side of the panoramic machine and up to the remote module.
4.2.2. Step-by-Step Instructions
NOTE: Verify that the power supply voltage selector is
set correctly for the power requirements in your area.
A.
Position power supply at base of panoramic machine.
B.
Route connector cable to the remote module at the top of the panoramic machine.
C.
Connect the connector cable to the remote module.
D.
Plug the power supply cable into a wall outlet.
4.3. Install PCI Board
4.3.1. Tools and Materials
To install the PCI board you will need a small screwdriver to remove the cover from your
computer; to secure the PCI board in its slot, and to secure one end of the data cable to
the remote module and the other end to the PCI board.
4.3.2. Step-by-Step Instructions
A.
Ensure the computer is turned off and not plugged into an outlet.
B.
Follow the instructions supplied with your computer to remove the cover. Locate an
empty PCI slot in the motherboard and install the PCI board.
B1051105 Rev. –
Rotograph Installation
20