GAIN
LINE OUT
P24
IN
IN
GAIN
10V
LOW
MID
HIGH
WARM
REV
MASTER
INSERT
OUT -15dB
1. FRONT PANEL - INSTRUMENT IN
1.1. MIC INPUT
This input is electronically balanced for XLR type connections. The new MIC/DYN channel is now
conceived for any kind of signal sources. You can plug in vocal microphones. The electronics will adapt to
any situation. No special action is required.
1.2. P24
The amplifier’s XLR input provides 24V phantom power for use with a condenser microphone. Most
condenser (and dynamic) microphones, along with some preamps, can be safely phantom powered. In
certain cases however, phantom power can cause damage to a device.
This tends to occur with unbalanced microphones, preamps or stompboxes that have been modified for
balanced XLR use.
If in doubt, please contact us to check the compatibility of your audio device before using the amplifier
1.3. 10V
Phantom power supplies the Jack connector with 10V for powering electret microphones.
1.4. STAT IN
Unbalanced input for the connection of jacks (6.3mm or 1/4”), with optimal sensitivity for high level sigals,
The electronics will adapt to any situation. No special action is required.
1.5. GAIN MIC
This variable gain preamplifier adjusts the sensitivity level to ensure the best possible processing of the
MIC signal through the channel.
It is important that this input level should be set and optimised in the best way to achieve the cleanest
sound possible.
1.6. GAIN INSTRUMENT
This variable gain preamplifier adjusts the sensitivity level to ensure the best possible processing of the
STAT signal through the channel.
It is important that this input level should be set and optimised in the best way to achieve the cleanest
sound possible.
1.7. HIGH, MID, LOW
These controls are devoted to high, medium and low frequency regulation. Offering cut and boost of ±15dB,
they allow a wide range of tonal variations to be explored. When the controls are positioned centrally there
is no cut or boost of the selected frequency band. The adjustment is on both channels
1.8. WARM
When engaged, this low-pass filter damps higher frequencies to produce a warmer sound when using
bridge-mounted pickups such as the SCHERTLER STAT-Series transducers for violin, cello and double
bass.
1.9. REVERB
This rotary control sets the level of the digital reverb on both channels.
1.10. MASTER
This rotary control regulates the Master on both channels.
1.11. LINE-OUT
This unbalanced jack plug enables the connection of external systems. The output volume depends on the
regulation of the MASTER-VOL.
1.12. INSERT
This stereo jack plug enables the connnection of an external device (compressor, equalizer, etc.) in series
to all the outputs.
1.13. DI-OUT
General output. XLR balanced type connector for connections of external systems. The output volume
does not depend on the regulation of the MASTER-VOL but is effected by changes in the channel volume.
1.1
1.3
1.2
1.4
1.5
1.6
1.7
1.8
1.9
1.10
1.11
1.12
1.13
