5
– FUNCTIONING AND USE
COD.
30Z12/24.B.2021
EN
THE PRESENT MANUAL BELONGS TO -
Schenker Italia
- ALL RIGHTS RESERVED
32
5.3.3
Working cycle with timer
1. Keep ON/OFF pressed for a while, then you will
hear 1-2-3-beeps. Once released ON/OFF, the
watermaker will work for 1-2-3 hours, then it will
flush and stop.
2. The unit can be stopped at any time by pushing
the ON/OFF button (without final flushing) or the
FLUSHING
button
(with
final
flushing).
5.3.4
Long flushing procedure
1. Push
FLUSHING.
A
3-minute
flushing
procedure with fresh water starts. Both ON/OFF
and FLUSHING lights of the buttons are on.
2. The unit can be stopped at any time by pushing
the ON/OFF button
CAUTION
If during normal running operation the system detects an irregular condition (high
pressure, etc…),
the system switches off automatically. Before restarting the watermaker again, be sure to identify the
cause of the anomaly and resolve the issue.
5.4 Reset procedure
If the watermaker has sucked in air (or if other problems occur), the automatic hydraulic valve may stop in a
central position.
In this case, when the unit has been started, it gets suddenly high pressure (close to 10 bar) without cycling.
After few seconds the computer recognizes the problem and turns off the pump.
In this case the system has to be manually restarted.
Although this circumstance might be very unusual, it does not damage the system, but it is necessary to reset
the valve with the following simple procedure:
