Operating and Installation Overvoltage Protection OVP 01 A
3
Issued: 20.12.2011
822.221 BA / EN
Y
WARNING!
Hot components!
Burns:
F
Blown fuses may only be exchanged once the system has been di-
connected from the power supply.
F
Blown fuses may only be replaced once the cause of the fault has
been identified and rectified.
F
Never bypass or repair fuses.
F
The rear of the device may become hot during operation. Do not
touch.
F
Only use original fuses rated as specified on the device.
F
The device is exclusively designed to be fitted in a vehicle
1.3 Operation
The overvoltage protection OVP 01 A has no operating elements that need
to be used on a day-to-day basis. It has the following display elements:
F
LED “mains” (fig. 1 pos. 6)
This LED lights up in yellow once the mains voltage is connected to
the overvoltage protection OVP 01 A. If the safety fuse in the overvol-
tage protection is faulty the LED does not light up, even if the mains
voltage is connected.
If the mains voltage is connected the yellow LED “Mains” must light
up. If it fails to do so it may be that overvoltage protection cannot be
ensured. This must be tested from time to time.
F
LED “Outputs” (fig. 1 pos. 7)
In normal operating mode this LED lights green, indicating that the
consumer is supplied with mains voltage. The LED does not light up in
the event of excess- or low voltage or if the safety fuse in the overvol-
tage protection is faulty. The consumer are not supplied with the
mains voltage.
There is a safety fuse (10 AT) in the extendable fuse carrier in the 230 V
mains plug. The mains plug is also fitted with a spare fuse.
1.3.1 Faults
In most cases faults are caused by a faulty fuse or an inactive 230 V circuit
breaker.
Please contact our customer service address if you cannot rectify the fault
using the following table.
If this is not possible, e.g. if you are abroad, a specialist garage can also
repair the overvoltage protection. In this case you must ensure that the war-
ranty is not invalidated by improper repairs being carried out. Schaudt
GmbH will not accept any liability for damage resulting from such repairs.
Flat vehicle fuses
