Bracket
install
ation
when wir
ing is
outside the wall:
1. Carefully poke through the
semicircular thin wall on the
corresponding side of the wire.
2. Drill 2 holes with a 6 mm diameter
and 35 mm deep according to the
spacing of the lamp bracket
holes
.
(Use screw anchors when needed)
3
.
Place the wiring through the hole
created on the side, then through the
base of the bracket. Fix the bracket on
the wall with the
Φ3,8*30 mm screws.
4. Remove the lamp cover and
hol
ding
-ring.
5. Attach the lamp to the bracket.
6
. Connect the desired power
supply
(12-24
V
AC
/DC
or
85-2
65
V AC
).
7. Fix the lamp to the bracket
with the
Φ3*12 mm screws.
8. Replace the lamp cover and
reattach
it to the base with the Φ2.3*8 mm
screws.
9. Replace the holding ring. The
installation is now complete!
7
