User manual
Page 8
BAMF - 02.00 - V05
3.3 Commissioning
3.3.1 Power
supply
- Connect the appliance to the mains supply.
- Operating voltage: 230 V / 10 A / 50-60 Hz.
3.3.2
Before you switch on the appliance and heater
Important:
- Remove the milk container.
- Pour 0.5 dl water fill the tank of the `bain Marie’ heater with 1.5 dl of water (for a 10 liter Milk
Foamer). The correct water level is essential for effective heat transfer. If you overfill the bain
Marie, the water will run over when you insert the milk tray.
- Re-insert the milk container.
3.3.3
Plastic-bag milk insert
- To make the appliance even easier to use and especially to make daily cleaning even more efficient,
we recommend using special-design bag inserts made from HDPE plastic. These bags do not impair
the quality of the milk produced to the slightest degree. They are taste and odour-free, safe for use
with food, heat resistant and biodegradable. They are designed for single use.
- Pour in the volume of milk you require up to a maximum of 5 liters. Replace the milk level sensor
and suction tube.
3.3.4
Switching on the machine
- Power up the machine by pressing the main switch which is located under the buttons protector flap
below the control panel (marked
4
in the diagram on page
3-9
).
3.4
Obtaining products (milk temperature dependent)
3.4.1
Automatic temperature control disabled
- If automatic temperature control is disabled, you can order a product immediately after refilling with
fresh milk.
3.4.2
Automatic temperature control enabled
- If automatic temperature control is enabled, you cannot order a product after refilling with fresh milk
until the milk reaches the programmed temperature. If you press any product button during heating,
the Cleaning button on the Milk Foamer flashes and the following message appears on the coffee
machine display:
- The milk will take approximately 16 to 20 minutes to reach the pre-set temperature.
Note:
Automatic temperature control can only be programmed as enabled or disabled by an M. Schaerer AG
authorised service technician.
The signal lamp lights up
Unable to select Product
milk temperature not reached
