Hardware Bag 1:
4 – 1-1/2” machine screws
4 – lock nuts
Hardware Bag 2:
1 – 3/8" cap nut for crank handle
1 – 3/8" washer for crank handle
3 – 8/32" hex nuts for shafts (extras)
2 – #12 washer
2 – 1/4 -20 thin lock nut
2 – 1/4 -20 x 2” truss head machine screw
2 – 1” black spacers
600 – heddles
90 – tie-up cords
10 - rubber bands
PARTS CHECK LIST
Accessory pack:
1 – brass reed hook
1 – warp beam crank handle
8 – 29" apron cords
2 – wheels
1 – Treadle Tracker
Wrapped onto rear beam:
3 – apron rods
2 – lease sticks (with holes)
1 – 22" treadle aid dowel
16 – heddle bars
UNFOLDING THE LOOM
1.
Remove all parts and plastic wrap from
the loom.
2.
Remove the wood shipping braces by
slightly loosening the black knobs and
Phillips-head machine screws holding
them in place. Discard the braces and
tighten the knobs and screws.
3.
Slightly loosen the two black fold
knobs on either side of the loom.
Note: Loosening the fold knobs all the
way or removing them may cause the
loom to collapse and could result in
injury to you or damage to the loom.
4.
Stand at the side of the loom. Hold the
front and rear beams together slightly.
Pull the slide lock bars (located on the
rear of the castle) out toward the back of
the loom.
5.
Continue holding onto the front and
rear beams and allow the loom to unfold
all the way. Push the fold knobs to the
bottom of the slots and tighten them.
6.
Remove the materials holding the
brake release pedal to the leg. Release
the brake release pedal by removing the
peg from the upper brake cord
(A)
, leav-
ing it in the marked (black) loop of the
cord as it sticks out through bottom of the
brake release pedal
(B)
.
slide
lock bar
black
fold
knob
UNFOLDING AND FOLDING
RELEASING THE BRAKE CORD
wood brace
machine
screw
knob
(A)
(B)
peg
