– 2 –
– 3 –
6.
Set the rear leg brace on a block of
wood or a few books to elevate the loom
back about two inches. Remove the
machine screws and barrel nuts holding
the rear leg brace to the outside legs at
hole [B] (Figure 1, page 2). Save the barrel
nuts for the next step.
7.
You’ll have two caster blocks left, one
with and one without a sticker. Line up the
bottom hole [E] of the
stickered
caster
block with the bottom hole [B] of the
right
outside leg, positioning the caster block
on the outer side of the leg with the caster
wheel toward the back. Insert a 1/4-20
x 4" Phillips truss head machine screw
through the caster block and leg. Thread
the machine screw into a barrel nut in the
rear leg brace and tighten, using a slotted
screwdriver to hold the barrel nut in
position. Repeat with the last
unstickered
caster block and the
left
outside leg.
8.
Re-attach the brake release pedal to the
right outside leg, using the lock nut and
3/8" washers you removed in Step 5 and
the new 3/8" washer. Insert the new 3/8"
x 3-1/2" hex bolt through a 3/8" washer,
then through the brake lever, then through
three 3/8 " washers (Figure 3). Now insert
the hex bolt through the top hole [F] in
the caster block and the top hole [C] in the
loom leg. Secure with the last 3/8" washer
and the lock nut.
9.
Attach the tops of the other three
caster blocks to the loom legs: From
the inner side of a leg, insert a 1/4-20 x
2-1/4" carriage bolt through hole [C],
then through the top hole [F]) in the
caster block (Figure 4). Cover the bolt
with a piece of scrap wood, then tap the
bolt into position with a rubber mallet or
hammer. Place a 1/4" washer and a 1/4-20
lock nut on the carriage bolt and tighten
the lock nut enough to draw the head of
the carriage bolt into the wood of the leg.
Complete this step for the left outside leg
and both inside legs.
FIGURE 3: RIGHT OUTSIDE LEG
1/4-20 x 4"
Phillips truss head
machine screw
E
C
F
lock nut
3/8" x 3-1/2" hex
bolt
brake release
pedal
3/8" washer
3/8" washers
FIGURE 2: CASTER BLOCK AND INSIDE LEG
D
1/4-20 x 3" Phillips truss
head machine screw
inside leg
FIGURE 4: CASTER BLOCK TOP
1/4-20 x 2-1/4"
carriage bolt
1/4-20 lock nut
1/4" washer
F
C
