– 2 –
– 3 –
PARTS LIST
4 – caster blocks with casters
2 – stroller bars
2 – 1/4-20 x 3" Phillips truss head
machine screws
2 – 1/4-20 x 4" Phillips truss head
machine screws
3 – 1/4-20 x 2-1/4" carriage bolts
2 – 1/4-20 x 1-1/2" hex bolts
2 – 1/4-20 x 1-3/4" hex bolts
1 – 3/8" x 3-1/2" hex bolt
7 – 1/4" USS washers
1 – 3/8" USS washer
7 – 1/4-20 lock nuts
2 – 1/4-20 wing nuts
TOOLS
#2 Phillips screwdriver
slotted (flat) screwdriver
rubber mallet or hammer
piece of scrap wood
7/16" or adjustable wrench
a couple of books
NOTES
1.
Please read all instructions prior to beginning installation. If you installed the
wheels that came with your loom, we recommend that you take them off before
installing the Wolf Pup 8.10 Stroller.
2.
Wolf loom legs are called out by where they cross each other. The legs that touch
the ground at the front of the loom are called “inside” legs because they are covered
by the “outside” legs when they cross at the loom center.
FIGURE 1: WOLF LEGS
treadle
support
rear leg
brace
barrel nut
(save)
C
C
A
B
right inside leg
right outside leg—brake release
pedal note shown
barrel nut
(save)
1.
Install the Wolf Stroller on a hard
surface. Open the loom to weaving
position (see front cover illustration). Set
the treadle support on a block of wood
or a few books to elevate the loom front
about two inches.
2.
Identify the right outside caster block.
One of the four stroller blocks has a
3/8" hole instead of a 1/4" hole. This is
the caster block intended for the right
outside leg and it comes with a sticker to
differentiate it from the others.
3.
Remove the machine screws and
barrel nuts that hold the treadle support
to the inside legs at hole [A] (Figure 1).
Save the barrel nuts for the next step.
4.
Set an unstickered caster block on the
outer side of an inside leg, with the caster
wheel toward the front and the floor (Figure
2, page 3). Line up hole [D] at the bottom
of the block to hole [A] in the leg. Insert
a 1/4-20 x 3" Phillips truss head machine
screw though the caster block and the leg.
Thread the machine screw into a barrel nut
in the treadle support and tighten, using a
slotted screwdriver to hold the barrel nut in
position. Repeat with a second unstickered
caster block and the other inside leg.
5.
Remove the lock nut holding the brake
release pedal to the outside right leg of the
loom. Remove the brake release pedal and
all hardware, saving all parts for Step 8.
carriage bolt
Phillips truss head
machine screw
lock nut
wing nut
hex bolt
