– 3 –
Hardware bag 2:
1X 3/8" cap nut for warp beam crank
handle
1X 3/8" washer for warp beam crank
handle
3X extra 8/32" hex nuts for shafts
2X #12 SAE washers
2X
1/4-20 slim lock nuts
2X
1/4-20 x 2" Phillips truss head
machine screws
2X 1" black spacers
TOOLS
#2 Phillips screwdriver
7/16" or adjustable wrench
PARTS
Wrapped onto warp beam:
3X apron bars
2X lease sticks (with holes)
1X 22" treadle aid dowel
16X heddle bars
Accessory pack:
1X brass reed hook
1X warp beam crank handle
8X 29" apron cords (or 2X 12-
foot apron cords for cherry
looms)
2X wheels
1X Treadle Tracker
600X heddles
80X tie-up cords
10X black treadle aid cords
Maintenance and Warranty Manual
Hardware bag 1:
4X 1/4-20 x 1-1/2" Phillips truss
head machine screws
4X 1/4-20 lock nuts
UNFOLDING THE LOOM
1.
Remove all plastic wrap from the loom.
Remove both shipping braces by slightly
loosening the back beam knobs and front
beam screws holding them in place. Discard
the braces and tighten the knobs and screws.
2.
Slightly loosen the black fold knobs on
each side of the loom (Figure 1). Generally, a
single turn will do.
Loosening the knobs all the way or
removing them can cause the loom to
collapse, which could result in injury.
3.
Stand at the side of the loom. Hold the
front and rear beams together slightly. Pull
the slide lock bars out toward the back of the
loom.
4.
Continue holding onto the front and rear
beams and allow the loom to unfold all the
way. Push the fold knobs to the bottom of the
slots and tighten them. You can push in the
slide lock bars to get them out of the way.
5.
Remove the packing materials holding
the brake release pedal to the leg. Release
FIGURE 1: UNFOLDING THE LOOM
slot in
castle
FRONT OF
LOOM
slide lock
bar
shipping brace
front beam
screw
fold knob
back beam
knob
Phillips truss head
machine screw
washer
lock nut
slim lock
nut
cap nut
