– 4 –
– 5 –
FIGURE 5: ATTACHING STROLLER BAR
stroller bar
1/4-20 lock nut
I
1/4-20 x 1-1/2" hex bolt
1/4" washer
see; fasten securely. Repeat for the other
caster block.
5.
Attach the hex bolt to hold the front
of the stroller bar: From the inside of
the loom, insert a 1/4-20 x 1-3/4" hex
bolt through hole [F] in the front caster
block. Secure with a 1/4" washer and a
1/4-20 lock nut. Place a 1/4-20 wing nut
on the bolt (Figure 3). Repeat for the
other front caster block.
6.
Set a caster block on the outer side
of an outside leg, with the caster wheel
toward the back and the floor (Figure
4). Line up hole [G] at the bottom of the
caster block to hole [B] in the outside
leg. Insert a 1/4-20 x 2-1/4" Phillips truss
head machine screw through the caster
block and leg. The screw will thread into
an insert in the height extender block
that you cannot see; fasten securely.
Repeat with another caster block and the
other outside leg height extender block.
7.
Attach the tops of the caster blocks:
Insert a 1/4-20 x 1-1/2" Phillips truss
head machine screw into the top hole
[H] of a caster block (Figure 4). The
screw will thread into an insert in the
height extender block that you cannot
see; fasten securely. Repeat for the other
outside leg height extender block.
8.
Attach the stroller bar to the rear
caster block: From the inside of the
loom, insert a 1/4-20 x 1-1/2" hex bolt
through hole [I] in the rear caster block
(Figure 5). Place a washer on the hex
bolt and then place the round hole at the
end of the stroller
bar over the bolt
so that the jog in
the bar points inward. Secure with
a 1/4-20 lock nut, using a 7/16" wrench
to attach the lock nut. Tighten the lock
nut securely enough to hold the stroller
bar in place, but loosely enough for it to
pivot. Repeat for the other rear caster
block.
•
FIGURE 4: REAR CASTER BLOCK AND OUTSIDE
LEG
G
H
1/4-20 x 2-1/4"
Phillips truss head
machine screw
1/4-20 x 1-1/2"
Phillips truss head
machine screw
