– 2 –
– 3 –
NOTES
1.
Please read all instructions prior to beginning installation. This instruction
booklet contains three different sets of instructions. Be sure that you are
following the correct instruction set for your loom before beginning any
installation.
2.
This kit contains parts to attach a Wolf Height Extender Stroller to any Wolf
loom with height extender. Not all of the included parts are needed to attach
the stroller to every loom; there will be parts left over when you have finished.
3.
The height extender blocks must be installed on your loom before you
install the Wolf Height Extender Stroller.
4.
Wolf loom legs are called out by where they cross each other. The legs that
touch the ground at the front of the loom are called “inside” legs because they
are covered by the “outside” legs when they cross at the loom center.
PARTS
4X
caster blocks with casters
2X
height extender stroller bars
4X
1/4-20 x 1-1/2" Phillips truss head
machine screws
2X
1/4-20 x 3-1/2" Phillips truss head
machine screws
2X
1/4-20 x 2-1/4" Phillips truss head
machine screws
2X
1/4-20 x 4" Phillips truss head
machine screws
2X
1/4-20 x 1-3/4" hex bolts
2X
1/4-20 x 1-1/2" hex bolts
8X
1/4" USS flat washers
2X
1/4-20 wing nuts
4X
1/4-20 lock nuts
REQUIRED TOOLS
#2 Phillips screwdriver
slotted (flat) screwdriver
two 7/16" and/or adjustable wrenches
lock nut
wing nut
flat washer
hex bolt
Phillips truss head
machine screw
WOLF HEIGHT EXTENDER STROLLER
A
ssembly
I
nstructIons
