of the ECU to read the signal.
After selecting GEN An from the main menu, you must choose one of
the 6 different operating modes listed below and the screen will look
like this:
A) It is generating tension
B) Voltage generated
C) Working mode
Manual:
A continuous voltage is generated between 0 and 5v. With the + and -
keys you raise or lower the voltage.
Lambda:
A voltage is generated that
oscillates between 0.2 and
0.8v continuously.
With the + and - keys change
the cycling speed.
TPS (Throttle Position Sensor)
:
A voltage that oscillates
between 0.8 and 4.7v is
generated as if the butterfly
were opening and closing
continuously over and over
again.
With the + and - keys change the cycling speed.
MAP (Manifold Air Pressure):
A signal is generated as if doing a full throttle.
1) When the test starts it emits a voltage as if the motor was stopped.
2) Pr outputs a voltage as if the engine was idling.
25/36
