To remove the battery pack, press
the battery release buttons and
pull.
12
.
To load the battery pack, slightly
push the battery pack upward to
the handle housing.
Battery loading and removal
Loading caulk material
Press the rod release button.
5
Hold the pull knob and pull it back
4
.
GETTING STARTED
Check up on the battery pack
to be fully charged.
Cut off tip of the sachet.
(sachet-pack only)
Remove the front cap.
Attach tube nozzle to front
cap.
Mount the plastic push disk
on plunger.
(sachet-pack only)
Reset and tighten the front
cap onto barrel.
Load sachet-pack /
cartridge sealant into
barrel.
Cut off nozzle tip at desired
diameter.
Lock the trigger
6
when the tool
is not in use.
To lock the trigger, push trigger
lock
7
at OFF site, the tool will
not operate.
Turn unit off and disconnect
battery pack before installing
and removing accessories or
performing maintenance.
Press trigger
6
to dispense
caulk .
Locking the trigger
Start and stop
Turn the disk from Left (Low) to
Right (High) for desired dispensing
speed.
Maximum achievable speed on the
trigger once the desired speed is
set on the disk.
Don’t start the tool from the lowest
point. The speed sometimes is too
slow to be noticed.
10
Stepless speed control disk
[DS series only]
Trouble Shooting
I
f the release button is stuck,
please gently pull and release
the trigger, this will retract the
ball screw automatically and
release the pressure. Then the
release button is functional.
A
B
C
D
E
F
G
H
5
12
4
10
7
6
6
