EN
FR
PL
CZ
IT
E-500RP /
User manual
5
After long time use of the tool, it could be possible that the metal chips from rivets setting remains in the nose
assembly of the tool and the tool efficiency will be influenced, therefore it is recommended to have the nose
assembly parts cleaned or the parts changed periodically.
1) To use the wrench (in accessories pack) and a spanner prepared by tool user:
2) To disassemble
nosepiece (#1)
on the tool by wrench.
4) To disassemble
clamping sleeve
(#3)
.
3) To disassemble
front sleeve
(#2)
.
5) To take out the
3-jaw set (#4)
from the
clamping sleeve (#3
), and take out the
assembly pusher (#5)
and the
pusher spring (#6)
from the tool, and
mandrel tube (#20),
and clean them all. Meanwhile to check the parts,
if any worn or damaged, to change the new parts.
6) To re-assemble the cleaned parts or new parts
back to the tool. To put the
pusher spring (#6)
onto the
assembly pusher (#5)
, and insert it
back to the tool where assembly
oil cylinder
(#13)
located.
Wrench hole 1 for assembly
rear adjustor (#22)
;
Wrench hole 2 for clamping
sleeve (#3)
;
Wrench hole 3 for
nosepieces (#1)
;
Wrench hole 4 for front
sleeve (#2)
;
7) To put
3-jaw set (#4)
into the
clamping sleeve
(#3)
, be sure the 3 jaws are seated in it correctly in
the position.
