The 9610 Microprocessor Intruder Alarm is a fully programmable system. Your
system will have been programmed by your alarm company engineer for the func-
tions and options specified at installation.
Access to the various user functions is divided into two user levels, determined by
the access code. Your system will have been handed over to you with the standard
default access code of '1234'. This access code has the authority of 'Manager',
thereby allowing you to change the default code, to programme the other six
available codes and to determine their authority as shown on pages 15 and 16 of this
manual.
Manager Codes
Permit the user access to the following system functions:
(a)
Arming, disarming and resetting the system (if not
programmed for 'Engineer Reset').
(b)
Omitting zones (if zones are programmed to be 'Omit
Allowed').
(c)
Omitting and re-instating 24 hour zones (if zones are
programmed to be 'Omit Allowed').
(d)
Setting 'Chime' function.
(e)
Setting system time and date.
(f)
Changing user code authority.
(g)
Changing and deleting user codes.
(h)
Viewing the event log.
(i)
Carrying out all test functions, e.g., Bell Test and Walk Test
(j)
Printing the event log.
Operator Codes
Restricts user access to the following system functions:
(a)
Arming, disarming and resetting the system ( if not
programmed for 'Engineer Reset').
(b)
Omitting zones (if zones are programmed to be 'Omit
Allowed').
(c)
Setting the 'Chime' function.
(d)
Viewing the event log.
(e)
Carrying out all test functions, e.g., Bell Test and Walk
Test.
Block Omit Access Code
Allows access to areas within Group 'D'.
(a)
Entering the 'Block Omit' code will allow the user access
to an area which has been defined as Group 'D'.
(b)
Detection within Group 'D' will be disarmed allowing
access, while detection on the other groups remain active.
(c)
The 'Block Omit' code can be used to disarm and re-arm
Group D only when one of the other three groups is armed.
(d)
This application could be used if a cleaner requires access
to a specific area without disarming the whole system.
(e)
The code will not allow a user to perform any function
other than arming or disarming Group D.
I
NTRODUCTION
1
1
