UNSET state.
WALK TEST
Press the number 5 (Walk Test) square then ENTER followed by the user code. The panel will
give a continuous tone. When a zone is violated the relevant zone number to return to the
will illuminate. All zones programmed to chime will do so when violated. When the chime option
is no longer required press the number 2 (CHIME) square then ENTER, followed by the user code
OMIT ZONES (MANUAL BYPASS)
CHANGING THE USER CODE
The user's code can only be changed by an engineer.
SELECTING ZONES TO CHIME
Press the number 2 (CHIME) square then ENTER, followed by the code number. The chime LED
Enter the user number and the DAT LED will extinguish. The exit tone will start. Within 5 seconds
press the omit square followed by the zone number to be omitted then press, 0 will appear in the
display. Repeat this if other zones are to be omitted. When all the required zones have been omitted
leave by the normal exit route. The system has set correctly when the exit tone stops
Enter the code number to silence the sounder. The CALL ENGINEER LED will be flashing. Enter
CUSTOMER EVENT LOG
Press the number 7 (SCROLL) square then ENTER> The alarm or the tamper LED'S will
illuminate and the display will show the last activation on the system.
TAMPER RESET
the code number. The tamper LED will illuminate and the display will show which zones has the
tamper fault. An engineer will need to visit the customer's premises
Written By Paul Wright
