Default Settings
When delivered from the factory, the panel is programmed as follows:
Zone 1, Entry/Exit, Chime, active in Part Set.
01 489
Zone 2, Entry Route, active in Part Set, Omit allowed.
02 39 OMIT
Zone 3, Normal Alarm, active in Part Set, Omit allowed.
03 19 OMIT
Zone 4, Normal Alarm, active in Part Set, Omit allowed.
04 19 OMIT
Zone 5, Normal Alarm, Omit allowed.
05 1 OMIT
Zone 6, Personal Attack.
06 5
Strobe output
11 49
Programmable output 1 is PIR Set Latch.
12 18
Engineer code is 7890.
20
Key switch operation is momentary.
21 0
PA gives audible alarm.
30 0
Customer reset.
31 0
2-Ply Entry Timer disabled.
32 0
Keypad PA enabled.
33 1
LEDs ON during Set.
34 1
Exit mode is Timed or Terminate.
35 0
Rearm after alarm three times.
40 3
External sounder delay zero (instant alarm).
41 0
External sounder duration three minutes.
42 2
Entry time is 20 seconds.
43 4
Exit time is 20 seconds.
44 4
Communicator outputs normal.
51 0
During Part set Entry/Exit zone starts entry timer.
60 0
During Part set Entry Route zone starts entry timer.
61 1
During Part set the exit mode is the same as full set.
62 0
Part set alarm response local only (no communications).
63 0
User 1 code
1234.
User 2 - 8 code
0001 to 0007 *
(inactive).
Duress code
OMIT OMIT
OMIT OMIT
(inactive).
* The default code for user two is ‘0001’, for user 3 it is ‘0002’ and so on up
to user 8, which is ‘0007’. Refer to the 601 User Guide for instructions on
changing the user codes.
Programming Commands
To change the factory default program, use the commands listed in this sec-
tion as follows:
1.
Enter the command number.
2.
Enter one or more digits to give the new program.
3.
Press ENTER.
The panel will give a double bleep to show that it has accepted the com-
mand. If you enter the command incorrectly the panel gives a single
tone.
19
Pr
ogramming
496219 Issue 1
601 installation 23/10/1998 10:09 Page 19
