Scantronic 460 Installation Instructions Download Page 3

DE1833

3

4.2 Compliance with Standards

This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there is no
guarantee that interference will not occur in a particular installation. If
this device does cause such interference, which can be verified by

turning the device off and on, the user is encouraged to eliminate the
interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one

which supplies power to the receiver.

– Consult the dealer or an experienced radio/TV technician.

WARNING!

 Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the
user’s authority to operate the equipment.

Summary of Contents for 460

Page 1: ...ection Range Up to 12 m Tripping Indication Indicator lights GREEN for about 3 sec Figure 3 Maximum Coverage Pattern ALARM and TAMPER Alarm Output Solid state relay N C up to 100 mA 30 V 30 Ω internal resistance Circuit opens for 2 3 seconds upon alarm Alarm Indication Indicator lights RED for about 3 seconds Event Counter Selectable 1 or 2 motion events Tamper Contacts Normally closed 50 mA resis...

Page 2: ...r by spraying various materials on the lens or by mechanical tampering with the optical system E As the ambient temperature of the protected area approaches the range of 32 C 40 C 90 F 105 F the PIR detector s performance can decrease F Even the most reliable electrical devices including this detector may go wrong due to an unexpected failure of a component part The above list includes the most co...

Page 3: ...is no guarantee that interference will not occur in a particular installation If this device does cause such interference which can be verified by turning the device off and on the user is encouraged to eliminate the interference by one or more of the following measures Re orient or re locate the receiving antenna Increase the distance between the device and the receiver Connect the device to an o...

Page 4: ...heldean Gloucestershire GL17 0SZ Product Support UK Tel 09068 616343 Between 09 00 and 17 30 Monday to Thursday 09 00 to 17 00 Friday CALLS CHARGED AT 60p PER MINUTE Product Support Fax 01594 545401 Internet www coopersecurity co uk 2001 SCANTRONIC 460 DE1833 REV 0 6 01 ...

Reviews: