4
1
Transportation and Handling
1.1
Transportation
The machine is delivered mounted on a pallet and wrapped in protective packaging.
1.2
Handling
The machine can easily be transported in the packaging in which it is delivered. If the machine rests on a
base, make sure that the base is securely bolted to the transport pallet.
1.3
Setup
Set up the machine on a solid, level surface. Fasten the
machine to the floor or to the workshop bench by using the four holes used for fastening the industrial
machine to the pallet.
1.4
Connection
Connect the machine only to the electrical voltage stated on the rating plate. Connect the machine as
displayed on the circuit diagram (see Section 5.3). The electrical connection must be performed by an
authorised fitter. In this connection, check that the motor has the correct direction of rotation (see the
arrow on the shielding).
1.5
Inspection before Use
The machine must be off during the inspection.
Check that the door of the deburring shielding is closed and securely fastened before use. The door must
be securely fastened with screws when the machine is in operation and may only be opened when the steel
brush is replaced. The steel brush must rotate freely; however, without being loose.
Make sure that the grinder is so aligned that it maintains 2 mm from the steel brush.
Make sure that the eye shield is clean and placed correctly and that the spark box is adjusted to approx. 5
mm from the steel brush and is properly fastened.
The first time the machine is started, it should run at max. speed for approx. 5 minutes before use. Make
sure that you keep a safe distance from the machine in the meantime.
