Installation
2.3
MOUNTING THE SCANNER PLUS FLEXIBLE
STAND
To install the scanner on the flexible scanner stand, lead the cable either
13
backward via the slit in the rear-side of the stand, or guide it vertically through
the stand to be connected to the scanner. Furthermore the stand should be
fastened to the counter top. You than can easily put the scanner in the stand.
To mount the stand you are advised to precisely follow the next steps:
1.
Gently pull the bottom disk out of the stand.
2.
Place the bottom plate on the counter and mark the places for the
mounting holes on the counter top and mark the hole to lead the cables
through.
3.
Drill the mounting holes and the lead-through hole.
ATTENTION
If you prefer not to drill in your counter, you can mount the stand
using the provided double-sided tape and have the cables leave the
foot at the rear, just above the circular basis.
4.
Fix the bottom plate on the counter top using the screws or tape from the
mounting kit.
Summary of Contents for Sirius S-7030
