Scantech Nexus N-3030, User Manual, Page: 22 / 40

Installing the Nexus N-3030 14
IMPORTANT
If the host system is an IBM 4683/4684 POS, the scanner with
IBM RS-485 interface should be connected to PORT 17 of the
host only.
If the host system is an IBM 4693/4694 POS, the scanner with
IBM RS-485 interface should be connected to PORT 9E of the
host only.
2.2 INSTALLING THE SCANNER ON A COUNTER SURFACE
To install the scanner without the flexible scanner stand, follow the instructions
below.
1.
Remove the two rubber feet from the end cover. Lead the communication
cable and power supply cable through the slit. Fasten the end cover to the
surface with two screws as illustrated in the figure.
NOTE
You can use the end cover as a template to mark the places for
the mounting holes at the counter surface and drill two holes.
If you do not want to drill holes in the counter top, the scanner
can be installed without fixing it to the surface. In this case the
rubber feet will prevent the scanner from sliding.