5
Parts Needed:
-
OdiySurveil (TM) Simulated Roller Lever SPDT AC Miniature Micro Switch
-
Female to female jumper wire cable
-
10K inline resistor
-
Heat shrink tubing or electrical tape
-
Phillips Drive, #2-28 Thread Size, 3/8" Length
-
P0087
–
Spherical Scanner Cover, Square 3D printed part.
-
(2) Phillips Drive, #2-28 Thread Size, 3/8" Length
Solder one end of the 10K resistor onto the common pin of micro switch. Cut the jumper wire in half, so
that each piece is approximately 100 mm (4 in) long. Strip the ends and solder one piece to the free end
of the resistor. Solder the other piece to the NC (normally closed) tab of the micro switch. Cover the
resistor with heat shrink tubing or electrical tape.
Install the micro switch into Spherical Scanner Cover in the orientation shown using the two screws.
Make sure the switch operation is not hindered by 3D printed plastic.
