SCANMASKIN Scan Combiflex 500i, Manual

Page: 64 / 86

4.11 Grinding
Refer to “Grinding Guide” for instructions and information about grinding.
4.12 Changing tools
Before changing tools, read “2.8 Safety regarding maintenance”.
This illustration shows how to change the tools.
Figure 43 How to fit the diamond segments on the Scan-On plate
1 Insert the segment at the widest part of the slot
2 Push the segment outwards
3 The segment is now fit on the Scan-On plate
To make sure that the tool is secured, use a small plastic hammer and slightly hit the tool out -
wards. In reverse this technique can be used to loosen tools that are stuck.
4.13 Using with generator
The generator must be equipped with protective earth and operated in accordance
with the current EN-VDE directives (this applies to the protective earth conductor in par -
ticular) in order to ensure that all safety devices are functioning and eliminate possible
damage to electrical components.
64
www.scanmaskin.com