RTC
®
5 PC Interface Board
Rev. 1.9 e
6 Developing User Applications
66
innovators for industry
Laser Control Initialization
(7)
Set the laser mode
(command
).
(8)
Set the laser control signals appropriate to your
laser system (command
(9)
Set the FirstPulseKiller length (YAG only)
(command
).
(10)
Set the delay of the Q-Switch signal (only for YAG
modes, in particular for YAG mode 5)
(command
).
(11)
Set the stand-by pulses (usually CO
2
only)
(command
).
(12)
Enable the laser control signals (see command
), if they have been
disabled via
The remaining settings (laser timing or laser delays)
are set via further control commands or list
commands.
Loading and Executing Lists
(13)
Load the list(s).
(14)
Enable the external start input if necessary
(command
).
Caution!
• Carefully check your application program before
running it. Programming errors can cause a
break down of the system. In this case, neither
the laser nor the scan head can be controlled.
