Figure 20 - Splash plate installation
Splash Plate Removal and Re-Installation
DSA 3017/3217 modules are furnished with a splash plate to protect the module from moisture.
The splash plate has a formed gasket on the bottom side which seals the edges of the top of the
module.
To Remove the Splash Plate:
1.
Loosen the six (6) allen head screws. These are captive screws.
2.
Carefully lift the plate from the unit.
3.
Verify that all of the o-rings stay with the module.
To install the splash plate:
1.
Inspect the o-rings for nicks and contamination. Replace any o-rings that do not
appear to be perfect.
2.
Inspect the header surface for contamination. This surface must be clean.
3.
Re-Install the splash plate by slipping it over the tubulations.
4.
Engage a few turns on each of the allen screws. Do not attempt to tighten these
screws until all have been started and the plate is aligned.
5.
Tighten, but do not over torque the allen screws.
NOTE:
The splash plate must be removed for access to the module.
24
