Connection to electric power take-off
Work on electric power take-off (PTO EL)
Scania Truck Bodybuilder
22:10-834 Issue 2 2021-11-11
© Scania CV AB 2021, Sweden
23 (32)
5.
Make sure that the voltage supply is cut by measuring the voltage between the
positive rail and negative rail on the incoming voltage supply; see illustration.
The voltage level must < 5 volts for an approved result. Also measure on the
outgoing connections in the terminal box.
6.
Remove the plugs on the side of the terminal box (1); see illustration
7.
Connect the cables prepared for the bodywork at the designated point. Make
sure that the bodywork is connected with the correct polarity. Fit the cable fit-
tings. Use the following tightening torque:
– Negative connection M10, tightening torque: 19.2 Nm
– Positive connection M8, tightening torque: 9.6 Nm
– Tightening torque, cable fitting: 15 Nm
8.
Measure and document the insulation value for the bodywork
9.
Refit the inner protective cover, tightening torque: 2.4 Nm
10.
Check the seal and refit the terminal box cover, tightening torque: 4 Nm
1
435 596
