3
Connection Port:
YPbPr IN Video signal input
YPbPr OUT Video signal LOOP OUT output
AUDIO IN Analog stereo audio input.
AUDIO OUT Analog stereo audio input LOOP OUT output
COAXIAL IN Coax digital audio input.
COAXIAL OUT Coax digital audio LOOP OUT output
OPTICAL IN Optical digital audio input
OPTICAL IN Optical digital audio LOOP OUT output
OUT 1 – 10 Remote Cat.5e output
DC 5V Power input
CONSOLE Reserve
LED Indication:
Bule
Power ON/OFF.
RJ45 Green
ON/OFF Video Signal
Flash Non-Detected Sync Signal
RJ45 Yellow
ON/OFF Digital Audio Signal
Flash Analog Audio input distortion
ON/OFF Instruction:
AUDIO
←
select digital audio input
→
select analog audio input
Auto Selection Digital Audio Input:
When audio input select “digital audio”, it will auto select the audio signal with input one,
either from coax or optical fiber.
When optical fiber and coax both with digital audio input, it will select optical fiber as
priority.
When digital audio input disconnect over 0.5 seconds, it will auto re-detect the new digital
audio input source.
Caution:
1. The wiring must away from any equipment with electromagnetic wave, i.e.: microwave,
cell phone, wireless AP, radio equipment, power lines in order to avoid interference or
affect picture quality , reliability.
2. Long CAT5 run will cause Skew picture, to use YE02DALS receiver with skew corrector
function to eliminate Skew.
Installation Tips:
Due to the inside of CAT5 cable that the pairs of wires are twisted at different rates,
AND the different quality on cable itself and installation that will cause different signal
arrival time at each pair. If there are big different at arrival time, that will cause skew
status. This is seen on the monitor as separation, or lack of convergence in colors.
Normally it happens on long CAT 5 cable runs.
