6
RJ45 pin define:
Link Cable (TIA/EIA-568-B)
1. Orange-white
Data 1 +
2. Orange
Data 1 -
3. Green-white
Data 2 +
4. Blue
Data 3 +
5. Blue-white
Data 3 -
6. Green
Data 2 -
7. Brown-white
Data 4 +
8. Brown
Data 4 -
Cable & Transmission Distance:
Link Cable use high quality Cat.5e UTP/STP/FTP or Cat.6 UTP cable
Transmission distance will be affected by equipment (Switch HUB),
cable quality…etc. When
using CAT.5e the max. Transmission distance up to 150M, using CAT.6 cable up to 180M.
You can also use model no: SR01 repeater for extended longer distance or using Gigabit Switch
hub which support
IGMP
protocol and
Jumbo Frame 8K
for signal distribution or extend distance.
System Default Settings:
HKM01B support
Unicast
and
Multicast
two mode, default is Multicast.
In Multicast mode it could be one to one, one to multi, multi to on or multi to multi applications.
The analog audio output of transmitter and input of receiver will be off in this mode, analog audio
only from transmitters send to receivers.
Analog audio bi-direction transmission only in Unicast mode, please refer to the web setting
chapter: Casting Mode
System default IP setting is Auto IP, it will assign 169.254.X.X (submask 255.255.0.0) to
transmitters and receivers, you could also set to DHCP or Static IP, please refer to web setting
chapter: IP Setup.
Bandwidth Chart:
The bandwidth will be varied based on different resolution. Higher resolution may not request
bigger bandwidth. Below Chart is the resolution and bandwidth status for reference.
Resolution (@60Hz)
Average Bandwidth (Mbps)
1080p
77 (24 ~ 91)
720p
46 (29 ~ 150)
480p
63 (36 ~ 73)
1600x1200 (UXGA)
59 (24 ~ 73)
1280x1024 (SXGA)
58 (31 ~ 76)
1024x768 (XGA)
118 (56 ~ 138)
800x600 (SVGA)
83 (64 ~ 107)
Under Gigabit Ethernet network, the total flow must not exceed 1000Mbps to avoid any delay on
video streaming. If the video play with 1080p resolution, the HE05BT Transmitter allow maximum
up to 10pcs for simultaneous video streaming.
USB Hot Key Function
：
In multicast mode HKM01B support multi USB keyboard and mouse in each receivers, just plug
and play, but only one USB FLASH drive / hard disk could be used at same time.
You have to click “Pause/Break” key three times of the keyboard on the receiver to establish USB
FLASH drive /hard disk connection.
