15
Note: Please hold the door by hand during step 4 to prevent
door dropping.
5 Remove the door and place it on a smooth surface with its
panel upwards. Remove the screws, as shown in the picture.
Change handle to the right side, then install screws again.
6. Place refrigerator flatwise, remove part (3) and then loose
screws (4) . Remove part (2) and part (1).
7. Screw out lower hinge, change it to the near hole site, and
then screw up and mount washer.
8. Just remount to the step 6,change part (1) to left and part
(2) to right and then fix them with screws (4) . Finally install
part (3).
9. Screw out the upper
hinge axis, turn the
upper hinge over and
fix axis on it. Then
place it at side for use.
10. Exchange wires both in
the left and right slots
of refrigerator body.
11 Move the door to appropriate position, adjust part (1) and
the door, Move the connecting wire (2) in the slot of the
door from right to left, and then fix part (1) and wire (2) by
screws (3). (Please hold the door by hand when installing)
12 Connect electrical connector (1) in accordance with step 3
and then install part (2) (which is in the plastic bag).
13 Reverse part (1) by 180°and install it onto the right corner
of the door, then mount part (2). (both of which are taken
down in step 2)
14 Take the reed switch out of the coping block (part (3) in
step 3) and mount it on another block for use (which is
with mark “R” in the plastic bag). Put the coping block just
removed back to the plastic bag.
Note: Be sure character side of reed switch fits well with coping
block.
