14
Installing the door handles
For the convenience of transportation, the door handles are sepa-
rately provided in a plastic bag, you can install the door handles
as follows.
1. Lever screw covers on the left side of the door, and then put
them back to the plastic bag.
2. Match the handle on the left side of the door, keeping axes
of screw holes in the handle and the door in a line, as the
picture shows.
3. Fix the handle with the special screws provided in the plastic
bag. And then install the handle covers.
Note: Install the handle cover as the follow figure shows: button
the buckle firstly, and then close the cover from the inside until
you hear the sound of
“popping” .
Reversing the door
The side at which the door opens can be changed, from the right
side (as supplied) to the left side, if the installation site requires.
Warning! When reversing the door, the appliance must not be
connected to the mains. Ensure that the plug is removed from
the mains socket.
Tools you will need:, 8mm socket wrench, Cross-shaped screw-
driver, Thin-blade screwdriver, 8mm wrench
Note: Before you start lay the refrigerator on its back in order to
gain access to the base, you should rest it on soft foam packag-
ing or similar material to avoid damaging the backboard of the
refrigerator. To reverse the door, the following steps are gener-
ally recommended.
1 Stand the refrigerator upright. Open the door to take out
all door racks (to avoid racks damaged) and then close the
door.
2 Open part (1) on top of the refrigerator body from right side
and then take down part (3) and part (4) on the door in the
same way. Take down part (2) and put it back to the plastic
bag.
3. Disconnect electrical connector (1) as well as electrical con-
nector (2) and then take down part (3).
4. Remove the screws (1), loose wire (2), and remove part (3).
