background image

 

•   Unplug your HighCube. 
•   Clean and dry the inside of the appliance. Leave the door 

slightly open to allow it to dry completely. 

•   A cooler which is unused without being cleaned may start 

to smell musty or develop mildew. 

 
 

DEFROSTING AND CLEANING 

Defrosting 

•   The surface of the evaporator ices up when the refrigera-

tor is working. This is an entirely normal part of operation. 

If the frost layer is more than 3mm thick, the cooler must 

be  defrosted  and  cleaned  to  avoid  unnecessary  energy 

consumption and inefficient operation. 

1.   Remove all items inside and unplug the unit. 
2.   After defrosting, reset the temperature selector to original 

position. 

Cleaning 

1.   Unplug your HighCube. 
2.   Wash the interior with warm water and neutral detergent. 
3.   Dry all surfaces thoroughly. 
 

Note:

 Do not use abrasive cleaners! 

 

To  ensure  efficient  operation  the  back  and  bottom  of  the 

cooler should be cleaned thoroughly. Use mild soapy wa-

ter to clean the door seal. 

Moving your HighCube 

•   Unplug the appliance 
•   Remove all items inside 
 

Note:

 Never hold the appliance by the door. 

Power Failure 

•   If  a  power  cut  occurs,  do  not  open  the  door  more  often 

than necessary in order to conserve cold air. 

 

TROUBLESHOOTING 

Before returning your HighCube to the store, check the follow-

ing points; you may be able to solve any problem yourself. 

Not Cooling 

•   Check power cable is connected and fuse is intact. 
•   Wrong  temperature  selected.  Adjust  setting  on  controller 

to position shown (see page 10). 

•   HighCube is overfilled. 
•   Appliance exposed to direct sunlight or a heat source. 
•   Door is opened too often. 

Unusual noises or noisy operation 

•   Appliance  is  not  on  a  level,  firm  surface  or  may  be  tou-

ching other items. 

•   Note: It is normal to hear refrigerant flowing as the com-

pressor stops and starts. 

Outer surfaces are wet 

•   Water source or leak too near the appliance – dry surfaces 

thoroughly and move the appliance. 

Inner surfaces are wet 

•   Door opened too often or kept open too often. 
•   Make sure that the door seals properly. 

 

 
 

Warranty 

This  HighCube  is  guaranteed  to  be  free  from  defects  in  parts 

and manufacture for 12 months from date of purchase, provid-

ed that the unit is used under the normal operating conditions 

shown within the manual. Your attention is drawn to the fol-

lowing: 
•   The Manufacturer will not accept any liability for damage 

or injury caused by improper use. 

•   The manufacturer will not be liable for any damage caused 

by  moving  the  appliance;  improper  power  supply;  defec-

tive wiring or fuses; accident, alteration, abuse or misuse 

of the appliance;  abnormal operating conditions; commer-

cial or industrial use; fire; water damage; or customer mis-

use. 

•   This warranty is void if service on the unit is performed by 

any  person  other  than  an  approved  technician,  or  if  the 

appliance is used for commercial purposes. 

This warranty is available only to the original purchaser and is 

not transferable. Your normal consumer rights are not affected. 
If  service  is  required,  DO  NOT  ATTEMPT  TO  REPAIR  UNIT 

YOURSELF. Please return unit to store. 
Proof of purchase will be required for any warranty claims. You 

must retain your original receipt. 
If  service  under  warranty  is  required,  you  will  be  required  to 

produce  this.  Please  also  retain  the  original  packaging  should 

the unit need to be returned. 
Please  note:  As  part  of  our  policy  of  continuous  product  im-

provement,  the  manufacturer  reserves  the  right  to  amend 

specifications without notice. 
 
 

Summary of Contents for High cube









Reviews: