9
1
st
li
ght
2
nd
li
ght
3
rd
li
g
h
t
Resi
stor
IN
OUT
IN
OUT
IN
OUT
120R 1W
DMX
control
（
receive
）
10
为
off
，
[1---9] is based light address code settings (8421 binary code format),
are all OFF, the address is 001.
Set to slave
machine
All DIP dial to“OFF”
Ⅵ
、
Appendi x
1
、
Us age of th e Signal Cable
、
Conn ector
The connection between the output and input, it’s available to use the 3 pins
XLR cable whi ch provided b y t he m anufact urer. Si gnal cabl e from the DM X
output of t he cont rol ler to the input of the first m ast er li ght, an d connect t o the
DMX input of s econd sl ave li ght from the DMX out put of the fi rst m ast er li ght,
analogousl y
，
till connect ed all the sl ave li ghts, and i ns ert the last connector t o
the out put of the final li ght .
If you want to prolong the connecti on of signa l cable, t he connection of the pins
bet ween male connector and fem al e connector shoul d be:1 t o 1; 2 to 2; 3 to 3,or
it will cause communication int erruption.
（
Notice
：
the di am et er of core of ever y
cabl e s houl d be 0.5m m at l east
，
doubl e core s helter cabl e shou ld be us ed
）
.The
si gnal connecting m ust use the att ached 3 pins X LR cabl e. Not ice, all the
internal l ead wire of the 3 pins X LR cable should not touch to each ot her or
connect to the connector.
The li ght is avail abl e to receive t he DM X512 si gnal , connect t he si gnal plug to
the panel which marked with “IN”
，
and connect it t o the next l ight. then, connect
to the “IN” of next light from the “OUT”. The DMX signal terminal organ is
recommended when t he li ghting si gnal is connecti ng. It will avoid to damage t he
si gnal which caus ed b y the noise, DMX t erminal organ is a XLR connector,
connect with a 120 Ω resistor between the pin 2 and pin 3 of the XLR connector, and connect
it to the last OUTPUT socket of the final light. Follow pi cture:
