INSTRUCTION MANUAL:
Read carefully before using the freezer
Keep it for further reference
TRANSPORTATION AND
INSTALLATION
1.
Place on level floor and remove the bottom packing, in order to
decrease the shock and noise. The angle between the
compartment body and ground should be no more than 45°
2. Enough space should be left between the freezer and the wall for
ventilation.
3.
Place the freezer away from heat source and do not expose to
direct sunshine.
4.
Do not install where there is moisture or where it can easily be
splashed by water.
5.
Do not place the freezer in environment prone to freezing.
6.
The appliance should not be used in open air and should not be
exposed to rain.
ADJUSTMENT AND RUNNING
1.
Adjustment of temperature: The storing temperature can be
adjusted by the thermostat of the compartment. The thermostat
should be adjusted according to different environment tempera-
ture and the food by rotating the knob of the thermostat. The knob
rotates clockwise from”1” to “7”
(or direction arc)and the inside
temperature turns down in summer (anti-clockwise rotation)and
up in winter(clockwise rotation). It is usually fixed to a certain point
before leaving the factory. Do not adjust too often or touch the
other parts.
2. Trial running: plug in and wait. The marked drop in temperature
within half an hour indicates that the freezer works properly. The
compressor should be left to run for a period of time(6 hours in
summer 4 hours in winter )before putting the food in.
SAFETY PRECAUTIONS
1.
The freezer should use a single 3-pin socket with (13A)fuse. A multi
–
plug outlet should not be used.
2. You should install a suitable automatic voltage regulator not less
than 500w when the voltage is outside the range from 187V to
242V.
3. The sockets of the freezer should be connected to stable fixed
connection. Under no circumstance should the wiring be connected
to such facilities as water pipe, gas pipe and so on.
4. Once power is cut off ,wait for at least 5 minutes before plugging in
again to avoid damaging the compressor or the system.
5.
Do not put combustible ,explosive or volatile dangerous articles,
heavily corrosive acid or alkali of liquid in glassware into the
freezer.
6. Children should be kept away from the freezer to avoid damage to
the inner container or any accidents being incured.
7. If the power cable damages, for avoid dangerous, must by
manufactory or its maintain a set or similar profession job the
personnel replaces.
FREEZING METHODS
1.
Do not put too much food into the freezer or exceed the loading
line.
2. Proper space should be allowed between foods to ensure cooling
air circulation.
3.
Never use corrosive detergent, hot water, or washing power to
clean the freezer.
4.
Do not use water to scour the freezer. Do not use hard brushes or
wire brushes to clean the freezer. 5.Do not use metal or sharp tools
for defrosting.
5.
Do not use electric heaters to heat up and defrost.
6. The green lamp is a power indicating lamp. When the power is on,
the lamp will be on.
TROUBLE SHOOTING:
The design and production comply with the relative security standard of
China. If you find it does not work as usual, plesae examine and handle
it according to the following table first. If the situation does not improve,
you must contact our after-sale service center or our special repair divi-
sion to examine and repair the appliance.
The following problems are not causes of breakdown:
Problems
Causes and resolutions
There is a sound of
liquid flowing in the
freezer
It is the sound of refrigerant flowing in the
circulating pipeline of the refrigerating sys-
tem. It is normal.
Too noisy
The freezer is not installed in a level
ground. Change the position.
The
refrigerating
system does not
work for a long time
but the inside tem-
perature is very low.
It is an indicator of high quality for its good
insulation and low cooling retention. It is
normal.
Model
Instruction
Plastic bag
Food
basket
SD351
1
1
3
SD451/SD551/SD65
1
1
1
4
