GB
2
INSTRUCTIONS FOR INSTALLATION
Congratulations on your new ANDERSEN wood burning stove. We are confident that you will enjoy your new
stove, especially if you follow the instructions and advice given below.
An original ANDERSEN stove possesses a number plate. The registration number can be attached to the invoice
that is to submit to the dealer in case of later complaints covered by the guarantee.
In the ANDERSEN-stove you will find the following:
1 oven mitten
1 handle to operate the shaking grate
Fitting for the flue collar
1 set of screws and hexagon spanners
Firelighters for the first lighting
Before the Stove is Connected to the Chimney:
Contact your local authorities to obtain the existing fire- and building regulations regarding the installation of
wood burning stoves, or ask your local experts in that field, e.g. the chimney sweep, to install your stove.
Security Distances:
The ANDERSEN convection stove is a double-skinned convection stove with an insulation heat shield at the
rear, resulting in a lower surface temperature. Please consult your local experts regarding the minimum distance
to the wall. However, we recommend that you leave enough space in order to facilitate the cleaning at the rear of
the stove.
The ANDERSEN radiation stoves must be connected in accordance with the regulations in force. Please consult
your local authorities.
Requirements of Flooring:
The stove is to be placed on a non-combustible surface, e.g. an original ANDERSEN base plate, floor tiles, or
the like. We recommend that the base plate extends at least 150 mm from the sides and at least 500 mm from the
front of the stove to prevent any sparks from ruining your carpet or floor.
CONNECTION TO THE CHIMNEY
We recommend that the stove is installed by an authorised dealer. From the factory the stove is prepared for top
mounting of the flue collar, but the ANDERSEN 4 and 8 can also be connected at the rear.
The stove should not be connected to a chimney of which the inside diameter is smaller than that of the flue
collar. The diameters of the smoke pipe and the flue collar should be the same. The gauge of the smoke pipe
should not be less than 1.5 mm.
The stove can be connected in the following ways:
Top Discharge:
Turn the flue collar and tighten the fittings under the top plate by using the delivered hexagon spanner.
Rear Discharge (Andersen 4 and 8):
Press the prestamped plate out of the reflector plate. Remove the cooking ring. Mount the flue collar from the
outside with the delivered fittings and bolts. Put the cooking ring in the hole for top discharge (after having
removed the ceramic joint).
Summary of Contents for ANDERSEN 8
Page 9: ...GB 9 ...
