12
Transportation and placement of the
refrigerator
Transportation
• Do not invert, traverse, press and shake the refrigerator.
When moving the refrigerator, angle of inclination shall not
be larger than 45°.
• When moving, do not make excessive pressure to the door
or top cover, otherwise deformation will occur.
• Slightly remove the refrigerator backward (less than 20°) to
rear truckle roll a short distance.
Placement
• Place the refrigerator at a ventilative place, far away from
heat source and direct sunlight. In order to avoid rust or
reduce insulation result, please do not place it at damp and
watered place.
• Top space for the refrigerator shall not be less than 30 cm.
Distance against two sides shall not be less than 10 cm,
Distance against to the wall shall not exceed 75 mm, provid-
ing convenience to open and close the door and disperse the
heat.
• Place the refrigerator on a flat and solid floor. (if it is not
stable, you can regulate the regulating legs)
Attention
Make sure the power line is not pressed by the refrigerator or
other articles.
Before connect the power line, make sure the voltage range of
the refrigerator accord with that of the power supply.
Correct application of the refrigerator
Ensure that the refrigerator is placed correctly and stably.
Be aware of all safety matters needing attention.
1. Connect the electricity
After connecting electricity, it will enter into ex-factory state.
2. Put food into the refrigerator
Suggestion: after working a time, the refrigerator will arrive
store temperature or after the first stop of the compressor, put
food into it, which is beneficial to retain freshness.
Note: if the set temperature is altered or new food is put in,
temperature inside the box will achieve the balance after a time,
which is determined by the temperature alteration degree, tem-
perature of ambient environment, opening frequency, quantity
of the food inside and so on.
Function introduction
Keys
A. Hi Humidity: High Humidity Mode
B. ON/OFF: start up or shut down the system
C. Increase temperature of the cooling chamber
D. Decrease temperature of the cooling chamber
Names of functions of display screen
1 High Humidity figure
2 Temperature region digitron
3 Temperature (℃) figure
Display control
• Power on for the first time: all shines for three seconds with
ringing of start bell. Defaulting temperature of the cooling
chamber is 5℃.
Normal operation display:
Temperature display region: when there is a failure, it will show
failure codes by turn at a priority order; without failure, it will
show the set temperature.
High Humidity figure: shine when the system is under High Hu-
midity Mode.
Display control:
1 Under the normal pattern, it will not shine any more after
thirty seconds without opening and key operation;
2 When the door is under open state, the display will shine all
the time and it will stop shining thirty seconds after the door
is closed.
3 When a failure happens and it is within ”Failure Code”, the
screen will shine for one time and stop to shine after thirty
seconds (if the buzzer has been ringing for a long time,
press any key to cancel the failure bell);
User Mode operation
Start-up and shutdown
Under start-up mode, press and hold ON/OFF key (B key) for
three seconds, the start bell will ring and the system will be shut
down immediately;
Under shutdown mode, press and hold ON/OFF key (B key) for
three seconds, the start bell will ring and the system will be
started immediately.
