28
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) con-
nector and make sure that it is fastened tightly in place. If the
water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and damage the
appliance.
Please Note: If the supplied hose cloes not fit your tap, please
contact your local plumbing supply center where adapters are
available for purchase.
Connection of the drain hose
Insert the drain hose into a drain pipe with a minimum diameter
of 4cm, or let it run into the sink, making sure to avoid bending
or crimping it. The free end of the hose must be at a height lower
than 60cm and must not be immersed into water to avoid the
backflow of it.
How to Drain Excess Water From Hoses
If the sink is more than1000 mm higher than the floor, the excess
water in hoses cannot be drained directly into the sink. It will be
necessary to drain excess water from hoses into a bowl or suit-
able container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly
fitted to avoid water leaks. Ensure that the water drain hose is
not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar
drain hose.
It must be no longer than 4 metres,otherwise the cleaning effect
of the dishwasher could be reduced.
Start the dishwasher
The following things should be checked before starting the dish-
washer.
1 The dishwasher is level and fixed properly.
2 The inlet valve is open.
3 Inlet hose connections are fully tightened and not leaking. 4
The wires are tightly connected.
5 The power is switched on.
6 The inlet and drain hoses are not kinked.
7 All packing and print materials should be taken out of the
dishwasher.
Remark:
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Error codes
Before you call service, look at the following
When some malfunctions come on, the appliance will display
error codes to warn you:
Codes
The rapid light flicker fleetly
• Longer inlet time.
• Faucets is not opened, or water intake is restricted, or water
pressure is too low.
Longer water inlet
• Overflow.
• Some element of dishwasher leaks .
Warning: If overflow occurs, turn off the main water supply be-
fore calling a service. If there is water in the base pan because
of an overfill or small leak, the water should be removed before
restarting the dishwasher.
