13
INSTALLATION
1 Remove the 4 screws "A" from both clamps and the 4
screws "B" (fig. 1).
2 Replace the 4 screws "A" and fit the trims provided "C" (fig.
2).
• The washing machine should be connected to the water
mains via the new tube supplied with the appliance (inside
the drum). Do not use the old tube for this purpose.
• Connect one end of the water inlet pipe with the elbow
bend to the electrovalve (top rear part of the machine) and
the other end to a tap or a plumbed-in 3/4" gas threaded
connection.
• Place the washing machine close to the wall, ensuring that
there are no bends or kinks anywhere in the tube.
• Hook the outlet pipe to the edge of the sink or preferably
to a fixed drainage outlet of a diameter greater than that
of the outlet pipe and at a height of min. 50 cm. and a
maximum of 75 cm. from the floor (fig. 4).
• If necessary, use the curved accessory to attach and sup-
port the outlet pipe more securely.
