10
Quick Start Guide SCAIME:
NUSG-eNodTouch-MS-FE_196776_D.docx
•
Confirm that the installation gasket is attached to eNodTouch unit and then place the unit into the Panel from the front.
•
It is strongly recommended that you use the installation gasket, since it absorbs vibration in addition to repelling water.
•
Press the installation fastener hooks securely into the insertion slots on eNodTouch.
•
Tighten the installation fasteners with a screwdriver. There are two insertion slots on both the top and bottom.
NOTE:
When installing to panel cut-out for monochrome model (eNodTouch-S) the eNodTouch-S Panel Cut-out Adapter (
ref.
632156
) is required. In this case, before placing eNodTouch-MS into the Panel:
-
Remove the gasket from this product
-
Attach the eNodTouch-S Panel Cut-out Adapter to this product:
1- eNodTouch-S Panel Cut-out Adapter
Electrical powering
•
Supplying a power voltage other than that specified will damage the power source and the unit.
•
When the FG terminal is connected, be sure the wire is grounded.
•
+
24V
-
0V
FG
Grounding Terminal
connected
to eNodTouch chassis
Conductor type
Simple Wire: 0.75 to 1.5mm2
Stranded Wire: 0.75 to 1mm2
RS485 interface for connection to eNod4
•
The serial interface is not isolated. Always connect the SG (Signal Ground) of the unit to the connected device.
•
SG (Signal Ground) and FG (Frame Ground) are connected internally
