![background image](http://html1.mh-extra.com/html/scag-power-equipment/swz36a-14fs/swz36a-14fs_operators-manual_1205932025.webp)
21
R
Section 6
6.4 TRACKING ADJUSTMENT
-NOTE-
Before proceeding with this adjustment, be sure
that the tire pressures are correct and the neutral
adjustment and the steering control rod adjustment
have been completed.
1. With the machine on a flat level surface, start the
engine, release the parking brake and place the
speed control lever into the speed that will most
often be used.
2. Squeeze the steering control levers and release the
neutral latch. Slowly release the steering control
levers, allowing the machine to move forward.
WARNING
Before attempting to make any tracking
adjustments, move the speed control lever to
the neutral position, place the blade engagement
switch in the off position, apply the parking brake,
and move the steering control levers into the
neutral position.
3. If the machine pulls to one side, stop the mower
by placing the steering control levers in the neutral
position. Using the adjustment wrench located on the
left side of the machine, turn the tracking adjustment
nut on the slower side counter clockwise until the
machine tracks straight.
4. Bring the steering control levers back to the neutral
lock position and check to see that the machine does
not creep forward on the adjusted wheel.
5. If the machine creeps in neutral, you have moved out
of the neutral band and will have to turn the tracking
adjustment nut clockwise until the machine does not
creep.
6. Repeat steps 1 and 2. If the machine continues
to pull to one side, stop the mower by placing
the steering control levers in the neutral position.
Turn the tracking adjustment nut on the faster side
clockwise until the machine tracks straight.
7. If tracking cannot be achieved, contact your Scag
servicing dealer.
Figure 6-3. Tracking Adjustment
6.5 THROTTLE CONTROL AND CHOKE
ADJUSTMENTS
These adjustments must be performed by your Scag dealer
to ensure proper and efficient running of the engine. Should
either need adjustment, contact your authorized Scag
service center.
6.6 CUTTER DECK BELT ADJUSTMENTS
WARNING
Before removing any guards, shut the engine off
and remove the ignition key. Wait for all moving
parts to come to a complete stop before beginning
work.
1. Remove the belt cover.
2. Adjust the cutter deck drive belt using a belt tension
gauge. Adjust the belt so that the belt moves 1/2"
with 10 pounds of pressure. Adjust the tension by
tightening or loosening the J-bolt. See Figure 6-4.
Nut
"J" Bolt
Belt
End Of L-Shaped
Bracket
Washer
SC400G
CUTTER DECK DRIVE BELT TENSION
ALIGNMENT IDLER - L.H.
Figure 6-4. Deck Drive Belt Adjustment