![background image](http://html1.mh-extra.com/html/scag-power-equipment/sttii-52v-26ch-efi/sttii-52v-26ch-efi_operators-manual_1205885035.webp)
29
R
Section 6
ADJUST HERE
LOOSEN HERE
Figure 6-6. Cutter Deck Pitch Adjustment
2. Turn the adjustment bolts on both sides either
clockwise to raise or counter-clockwise to lower the
front of the cutter deck until the measurements are
equal. Tighten the elastic stop nuts.
ADJUST HERE
LOOSEN HERE
Figure 6-7. Cutter Deck Pitch Adjustment
- NOTE -
To prevent the cutter deck from teetering, all four
(4) cutter deck hanging chains must have tension
on them. If all four chains do not have tension on
them and the deck teeters, you must readjust the
cutter deck as outlined in the procedures above.
All measurements should be taken from the top
edge of the deck as the deck has an uneven
bottom edge.
CUTTER DECK HEIGHT
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck height,
be sure that the mower is on a flat, level surface and the
tires are properly inflated.
1. Check the cutter deck cutting height by placing
the lanyard pin in the 4-1/2" position on the cutting
height index. Release the deck from the transport
position and allow the deck to move to the 4-1/2"
cutting height position.
2. Check the measurement from the floor to the cutter
blade tip. If the measurement is not at 4-1/2", an
adjustment can be made using the deck height
control rod.
3. Loosen the jam nuts on both ends of the deck height
control rod. See Figure 6-8.
LOOSEN HERE
CONTROL ROD
Figure 6-8. Cutter Deck Height Adjustment
4. Turn the control rod (See Figure 6-8) until the
measurement from the floor to the cutter blade tip is
at 4-1/2". Tighten the jam nuts on the control rod.
Summary of Contents for STTII-52V-26CH-EFI
Page 6: ...IV R Table of Contents...
Page 61: ...55 R Section 8 NOTES...
Page 87: ...81 R Section 8 NOTES...
Page 89: ...2016 Scag Power Equipment Division of Metalcraft of Mayville Inc...