32
R
Section 7
WASHER
HEX HEAD BOLT
CUTTER
BLADE
SPINDLE
ASSEMBLY
CUTTER BLADE
SPACER
HEX HEAD
BOLT / NUT
CUTTER
DECK
SPINDLE
SHAFT
HEX NUT-TORQUE
TO 75 LB-FT
Blade Replacement
Figure 7-5.
- NOTe -
Be sure that the blade is installed with the lift wing
toward the top.
Install the spacer onto the blade bolt and insert the
5.
bolt into the cutter spindle shaft.
Install the hex nut to the blade bolt at the top of the
6.
cutter spindle. Secure the blades from rotating and
torque to 75 lb-ft. See Figure 7-5.
TIRES
7.10
Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels
Flat Free
Drive Wheels
12 PSI
Rear Steering
15 PSI
BODY, DECk, AND UPHOLSTERY
7.11
Keep the entire mower clean to inhibit serious heat
damage to the engine or hydraulic oil circuit.
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
After each use, wash the mower and cutter deck.
1.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
Do not spray electrical components.
2.
Use a mild soap solution or a vinyl/rubber cleaner to
3.
clean the seat.
Repair damaged metal surfaces using Scag
4.
touch-up paint available from your authorized Scag
dealer. Wax the mower for maximum paint protection.
