3
R
Section 2
2.2 ASSEMBLY INSTRUCTIONS - SZL36 /
SFZ36 CUTTER DECK COMPONENTS
1. Install the right side cutter deck baffle as shown in
Figure 2-3. Secure using (2) 3/8-16 x 1" carriage
bolts, (2) 3/8" flatwashers and (2) 3/8-16 elastic stop
nuts.
3/8-16 x 1”
3/8-16 ELASTIC
STOP NUT
3/8 FLATWASHER
3/8-16 x 1”
3/8-16 ELASTIC
STOP NUT
3/8 FLATWASHER
Figure 2-3. SFZ36 Right Side Baffle
2. Tighten the hardware.
3. Remove and retain the hardware used to secure
the grass catcher boot mounting bracket onto the
boot assembly supplied with the grass catcher. See
Figure 2-4. The grass catcher boot mounting bracket
will be replaced in Step 4.
REMOVE & RETAIN
HARDWARE
REMOVE
BRACKET
Figure 2-4. Remove GC Boot Mounting Bracket
4. Install the new grass catcher boot mounting bracket
(p/n 424915) supplied with the SZL36 / SFZ36
Installation Kit onto the boot assembly. Secure
using the original hardware that was removed in the
previous step. See Figure 2-5.
ORIGINAL
HARDWARE
424915
BRACKET
Figure 2-5. GC Boot Mounting Bracket Installation
5. Install the deflector baffle included with the catcher
installation kit to the discharge boot and secure
using (2) 1/4-20 x 1" hex head bolts, (4) 1/4"
flatwashers and (2) 1/4-20 elastic stop nuts. See
Figure 2-6. Tighten the hardware.
1/4-20 x 1”
1/4-20 ELASTIC
STOP NUT
1/4” FLATWASHER
1/4” FLATWASHER
Figure 2-6. Blower Installation
6. Install the new cutter blades included with the
SZL36 / SFZ36 Installation Kit and secure using the
hardware removed in Section 2.1, Step 4. On the
right side of the cutter deck, install the cross cutter
blade below the high lift cutter blade as shown in
Figure 2-7. Use optional Blade Buddy tool P/N 9212
to assist in securing the cutter blades.
-NOTE-
The cross blade is installed on the right side
only.